Finally, round wire from a rolling mill! Mill includes a gear reduction to make it easy to roll consistently smooth round wire along with a small flat area and side roller for four half round sizes.

Simply start with a square (or round) wire and use the mill in the same way as any other manual mill. Square wire will gradually compress to round as it passes through consecutively smaller grooves. Note that a round section will be formed before the rollers are fully closed. If you continue to roll and fully close the rollers, this will create a slightly oval wire.

To avoid flashing, rotate the wire 90 degrees on every pass. If flashing forms, reduce the amount of reduction on each pass.

Specifications:

• Extended side rolling area with 4 half-round grooves (1.5mm, 2mm, 3mm, 4mm)
• 18 Round wire rolling grooves
• Main rolling area: 130mm
• Flat rolling area: 20mm
• Roll diameters: 60mm
• Max sheet thickness: 6mm